Table of Contents
Advertisement
ASSEMBLING MOTOR MOUNTING
BRACKET AND PLATE
1.
Assemble the motor mounting bracket (A) to the
two posts (B) and tighten set screws (C), as shawn
in Fig. 5.
2.
Loosen screw thal holds rod (D) in place and
remove rod (D) from motor mounting bracket '(A) Fig. 5.
3.
Assemble motor mounting plate (E) Fig. 5, to the
motor mounting bracket (A) and reassemble rod (D)
to the plate and bracket.
Make sure screw thal holds
the rod (D) in place is 1ightened into the V·grùove in
the rad.
RECOMMENDED MOTOR FOR YOUR SAW
The motor recommended for use with your saw is the
1
Y,"
H,P,
Bali
Bea ring, Capacitor Start. 115 Volt 60
cycle motor.
This motor has been specially seleoted to best supply
power to your machine and the relative safety of the
machine is enhanced by its use.
We therefore strongly
suggest thal only this motor be used as the use of other
motors may lie detrimental to the performance and safety
of the saw.
Fig.
6
--MOTOR MOIJNTING PLATE
~
- - - SHAKEPROOF EXT. LOCKWASHf..R
~-;
__ - - F L A T WASHER
~----HEX
NUT
5
ASSEMBLING MOTOR, MOTOR PULLEY,
BELT
&
PULLEY GUARD, AND V-BELT
If
you
purchased the motor recommended for use with your
saw, make sure the mot oris DISCONNECTED from the power
source and assemble it toy our saw as follows:
L
Assemble motor pulley (A) Fig,6, to the motor shaft
with hub of pulley out. Tighten._set .. screw in motor pulley
against key in motor shaft, as shawn in Fig. 6.
2.
Assemble motor to
m~tor
mounting plate, as shawn in
Fig 6 using the hex head screws, flat washers, shakeproof
lockwashers and n4!s supplied, Do not tighten at this lime.
3.
Fig. 6A îllustrates the proper relationship of the mo tor
mounting hardware. CAUTION: The proper grounding of the
mot or, ta prevent shock hazard, depends on the use of the
shakeproof lockwashers in the manner shawn in Fig. 6A.
Advertisement
Table of Contents
