Table of Contents
Advertisement
NetLinx Security
Security Help menu
Type help at the prompt in the Telnet session to display the following help topics:
Security Help Menu Options
Command
----- Help ----- <D:P:S>
? or Help
DATE
DEVICE HOLDOFF ON|OFF
DEVICE STATUS <D:P:S>
DNS LIST <D:P:S>
DISK FREE
GET DEVICE HOLDOFF
GET IP <D:P:S>
HELP SECURITY
IP STATUS
MEM
MSG ON|OFF
OFF [D:P:S or NAME,CHAN]
ON
[D:P:S or NAME,CHAN]
PASS [D:P:S or NAME]
PING [ADDRESS]
PROGRAM INFO
PULSE [D:P:S or NAME,CHAN]
REBOOT <D:P:S>
RELEASE DHCP
ROUTE MODE DIRECT|NORMAL
SEND_COMMAND D:P:S or
NAME,COMMAND
SEND_STRING D:P:S or
NAME,STRING
SET DATE
(Cont.)
38
Description
(Extended diag messages are OFF)
<D:P:S>: Device:Port:System. If omitted, assumes master.
Displays this list.
Displays the current date.
Sets the master to holdoff devices (i.e. does not allow them to report
ONLINE) unitl the NetLinx program has completed executing the
DEFINE_START section.
If set to ON, any messages to devices in DEFINE_START will be lost,
however, this prevents incoming messages being lost in the master
upon startup. When DEVICE_HOLDOFF is ON, you must use ONLINE
events to trigger device startup SEND_COMMANDs.
By default, DEVICE HOLDOFF is OFF to maintain compatibility with
Axcess systems where fdevices are initialized in DEFINE_START.
Provides information about the specified device.
Displays the DNS configuration of a device.
Displays the amount of free space on the disk.
Displays the state of the device holdoff setting in the master
Displays the IP configuration of a device.
Displays security related commands.
Provides information about NetLinx IP Connections.
Shows size of the largest block of available memory.
Enables/Disables extended diagnostic messages.
Turns off the specified channel.
Turns on the specified channel.
Puts the Session in pass mode to the specified device.
• Mode is exited by ++ ESC ESC.
• Display Format is set by ++ ESC n
If n is A, format = ASCII
If n is D, format = Decimal
If n is H, format = Hex
Pings an address (IP or URL).
Specify -a option for reverse lookup.
Displays a list of program modules loaded.
Pulses the specified channel.
Reboots the device.
Releases the current DHCP lease.
Set the Master-Master route mode.
Sends the specified command to the device.The Command uses
NetLinx string syntax.
• Ex: send_command 1:1:1,"'This is a test',13,10"
• Ex: send_command RS232_1,"'This is a test',13,10"
Sends the specified string to the device.
Set the current date.
Get other manuals https://www.bkmanuals.com
NetLinx Master Cards and Modules
Advertisement
Table of Contents
