Table of Contents
Advertisement
NXC-MPE Master Port Expander Card
Rear panel components
FIG. 9 shows the rear panel components NXC-MPE Master Port Expander Card.
NXC-MPE
Master-Ethernet
12VDC
PWR
FIG. 9 NXC-MPE Card (shown mounted in a NXS-MHS Module - rear view)
SPE Port Connection/Wiring
Use an RJ-11 cable (6" max. length) to connect the NXC-MPE to an AXB-SPE Slave Port
Expander.
The SPE OUT port on the rear panel of the NXC-MPE connects to the EXPANSION IN port on the
rear panel of the AXB-SPE (FIG. 10).
FIG. 10 AXB-SPE (rear panel)
You can daisy chain multiple AXB-SPE's by connecting the EXPANSION OUT on the primary
AXB-SPE to the EXPANSION IN port on the secondary, as shown in FIG. 11. The connecting RJ-
11 cable should not exceed 6 inches in length. Repeat this process to connect up to nine AXB-
SPE's.
14
ETHERNET
10/100
SPEED
FD
AXlink
EXPANSION OUT
PROGRAM
EXPANSION IN port (RJ-11)
Get other manuals https://www.bkmanuals.com
Ethernet 10/100 LEDs
Ethernet 10/100 connector
ICSNet connectors/LEDs
ICSHub In/Out connectors/LEDs
IN
OUT
ICSNet
ICSHub
PROGRAM port connector
Expansion port connector (RJ-11)
12 VDC power supply connector
NetLinx Master Cards and Modules
Advertisement
Table of Contents
