Download Print this page

NCR 7409-K313 Instruction Manual

Fixed angle mount bar code scanner

Download this manual

7409-K313

Fixed Angle Mount

Bar Code Scanner

Kit Instructions

Issue A

Page 1 7409-K313 Fixed Angle Mount Bar Code Scanner Kit Instructions Issue A...
Page 2: Revision Record
Revision Record Issue Date Remarks Aug 2011 First issue...
Page 3 Introduction This kit provides a Bar Code Scanner for the following terminals.  NCR RealPOS 25 (7610)  NCR RealPOS 50 (7611) The assembly installs on the front of the 7409-K035 Fixed Angle Mount. Components Screw, 6-32 x 1/4, Phillips, PH 006-8611016 Screw, M3 x 0.5 x 6 mm, FH, Phillips...
Page 4: Installation Procedures
Installation Procedures 1. Unplug the terminal power cord and turn off the power to any connected peripheral devices. 2. Remove the screws (2) in the sides of the Fixed Angle Mount. Hex Screw (One Each Side)
Page 5 3. Rest the bottom of the display on the Display Support. Display Support 4. Remove the Blank Faceplate from the Fixed Angle Mount (2 screws). Blank Faceplate...
Page 6 5. Connect the Scanner Cable to the scanner. 6. Hook the bottom of the Fixed Angle Mount Faceplate and Image Scanner Assembly onto the bottom edge of the opening on the front of the Fixed Angle Mount and secure it with screws (2). Fiuxed Angle Moutn Faceplate...
Page 7 7. Remove the terminal Cable Cover. 8. Connect the other end of the scanner cable to a USB Connector on the I/O Panel. USB B USB A 9. Close the Cable Cover. 10. Close the Display onto the Fixed Angle Mount and secure it with screws (2). Hex Screw (One Each Side)