Revision Record Issue Date Remarks A Apr 2011 First issue ...
Page 3
Introduction This kit provides Bar Code Scanner for the NCR EasyPoint Advantage (7404) and NCR SelfServ 60 (7409). The assembly installs on the front of the 7409‐K035 Fixed Angle Mount. 29722 Components Fixed Angle Mount Scanner Mount 497-0472477 Screw, 6-32 x 0.375, Phillips, Pan Screw, M3xPo.5 x 6 mm, Phillips, Flat Hd 006-8613117 006-8612557 Class 2 Laser Warning Label Fixed Angle Mount Scanner Faceplate 497-0460286...
Installation Procedures 1. Unplug the terminal’s power cord and turn off the power to any connected peripheral devices. 2. Open the unit to the service position. a. Remove the screws (2) in the sides of the Fixed Angle Mount. Screw (One on each side) 26681 ...
Page 5
b. Tilt the display as shown and rest the display on the Display Support. Display Support 29723 Note: Place the Display Support behind the extension on then Display Hinge Bracket. Bracket Extension Display Support 24753 ...
Page 6
3. Connect the 1 meter Scanner Cable to the scanner. 29540...
Page 7
4. Remove the screws (2) that secure the Blank Faceplate. 5. Pivot the top of the Blank Faceplate out at the top as shown to remove it from the Fixed Angle Mount. 7409-K036 Blank Faceplate 29545 ...
Page 8
6. Hook the bottom of the Scanner Faceplate onto the bottom edge of the opening on the Fixed Angle Mount and then secure the assembly with screws (2). 29546 7. Route the Scanner Cable through the Bracket Cable Guides on the back of the terminal and then connect it to a USB connector on the I/O Panel. 29547 ...
Page 9
8. Install the Cable Cover on the terminal (use the same three screw holes that were used to mount the previous scanner assembly. Cable Cover 29522 9. Adhere the Safety Label on the Scanner Mounting Bracket as shown. Safety Label 29548 10. Close the Display and secure it with screws (2). ...