Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NCR K350
Summary of Contents for NCR K350
- Page 1 NCR K350 RealScan Remote Imager Configuration Guide Issue A...
-
Page 2: Revision Record
Revision Record Issue Date Remarks Aug 2013 First issue... - Page 3 Introduction The NCR RealScan Remote Imager is a highly flexible and convenient alternative to a handheld scanner. The Imager module has a long cord which permits the store personnel to mount it in a convenient place for the customer, without requiring precious space on the sales counter.
-
Page 4: Installing The Imager Module
Installing the Imager Module The RealScan Remote Image is easily connected to the existing USB ports of NCR 78xx series scanners. The USB Ports on each respective scanner are encircled in red below: 7878 7874 7884 7812 32441... -
Page 5: Programming Instructions
The host scanner (7878, 7874, 7884, or 7812) must be programmed so that it can perform the following: Permit 2D data to pass through the POS • Enable the K350 mode • IMPORTANT The following programming instructions are ONLY meant to enable the newly installed RealScan remote imager module. - Page 6 R0042 Enable 2D Pass–Through Function for all 2D Types Note: The passed–through PDF data is transmitted in ASCII when RS–232 Serial or NCR USB is used. This data format is required by NCR OPOS for 2D bar codes. R0055...
- Page 7 R0063 R0057...
- Page 8 Activate Beep Sounds on the 7878 Scanner Note: This function is optional. The imager module produces beep sounds on its own. R0052 R0048 R0053...
- Page 9 Enable the Imager Module on the 7884, 7874, and 7812 Caution: Do not perform this sequence on the 7878. If a K150 has already been installed, performing this on a 7878 turns–off the embedded imager. R0056 R0059 R0048...
- Page 10 R0044...
-
Page 11: Program The Imager Module
Program the Imager Module The RealScan Remote Imager provides a limited number of symbologies enabled at the factory, including the following: UPC–A • UPC–E • EAN–8 • EAN–13 • PDF417 • GS1 Databar 14 (RSS–14) • GS1 Databar Expanded (RSS–14 Expanded) •... - Page 12 Enable Other Individual Bar Code Symbologies Take note of the following reminders while scanning the bar codes. • Print and fold these pages in such a way that only one bar code shows per page. Carefully scan the bar codes to the window so that the imager can see and read •...
- Page 13 Note: This bar code also enables MicroQR.
- Page 14 Note: Ensure that the following four symbologies are also enabled on the 78xx scanner.
- Page 15 Sample 2D Bar Codes Sample QR Code Sample MaxiCode...
-
Page 16: Reset The Imager To Default
NCR USB. The bar code also resets the imager to the factory default symbologies, without affecting the basic communication to the NCR scanner.