Table of Contents
Advertisement
Figure 104
1. Adjusting screw
2. Bracket
11.
Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
105).
12.
Set the height-of-cut lever to the 76 mm (3
inches) position; refer to
of Cut (page
29).
13.
Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
Figure 105
Bottom view
1. Block—73 mm (2-7/8
inches)
g334850
3. Set the gap to 22 to 29
mm (7/8 to 1-1/8 inches).
(Figure
Adjusting the Height
g038090
2. Welds
Block Height and Rake Table
Deck
Front Block Height
Size
All mower
73 mm (2-7/8 inches)
decks
14.
Carefully rotate the blades side to side
102).
15.
Lower the mower deck to the 76 mm (3 inches)
position; refer to
(page
29).
16.
Loosen the bolts
and ensure that the mower deck is sitting
securely on all 4 blocks.
17.
Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
18.
Tighten the 4 bolts.
1. Deck-lift arm bolts
19.
Ensure that the blocks fit snugly under the deck
skirt and that all attachment bolts are tight
20.
Continue leveling the deck by checking the
front-to-rear blade slope.
21.
Check the blades for levelness and repeat deck
leveling procedure if necessary.
22.
Raise the deck to the transport position (127
mm or 5 inches).
23.
Install the lift-assist spring adjusting screw
previously removed in step 10.
24.
Set the gap between the spring and the bracket
to 22 to 29 mm (7/8 to 1-1/8 inches).
73
Rake
4.8 to 6.4 mm (3/16 to 1/4
inch)
Adjusting the Height of Cut
(Figure
106) on all 4 corners
Figure 106
(Figure
g412952
Advertisement
Table of Contents
