Toro 77281 Operator's Manual page 51

Note:
Ensure that the primary filter is fully
seated by pushing on the outer rim while
installing it.
Important:
Do not press on the soft, inside
area of the filter.
4. Install the air-cleaner cover with the breather cap
down, and rotate so that the retaining clamps
lock the cover in place
Servicing the Engine Oil
Engine-Oil Specifications
Oil Type: Detergent oil (API service SJ or higher)
Oil Capacity: 2.0 L (68 fl oz) with the filter; 1.9 L (66
fl oz) without the filter
Viscosity: See the table below.
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep your hands, feet, face, clothing and
other body parts away the muffler and other
hot surfaces.
Important:
Do not overfill the crankcase with oil
because damage to the engine may result. Do not
run engine with oil below the low mark because
the engine may be damaged.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
(Figure 66).
Figure 67
3. Check the engine-oil level as shown in
68).
g359987
Changing the Engine Oil and Filter
Service Interval: Every 100 hours or yearly,
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely.
2. Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
51
Figure 68
whichever comes first
- position, and
EUTRAL LOCK
(Figure
g373146