Table of Contents
Advertisement
Installing the Battery
1.
Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
77).
2.
Install the positive (red) battery cable to the
positive (+) battery terminal.
3.
Install the negative (black) battery cable and
ground wire to the negative (-) battery terminal.
Note:
For MyRide machines, ensure that the
ground cable does not rub against the trailing
arm or lower shock mount
Figure 79
1. Ensure that the ground
cable does not rub against
the lower shock mount.
2. Ensure that the ground
cable does not rub against
the trailing arm.
4.
Secure the cables with 2 bolts, 2 washers, and
2 locknuts
(Figure
5.
Slide the red terminal boot onto the positive (+)
battery terminal.
6.
Secure the battery with the rubber strap
77).
(Figure
(Figure
79).
3. Ground cable
77).
(Figure
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows check the
component and circuit for a malfunction or short.
The fuses are located in the rear, near the engine
(Figure
80).
1.
To replace the fuses, pull out the fuse to remove
it.
2.
Install a new fuse
g334253
1. Fuse block
59
(Figure
80).
Figure 80
g412770
Advertisement
Table of Contents
