Table of Contents
Advertisement
OPERATING THE PRODUCT
WARNING: Always use two hands to operate
the product. Hold the product with the right
hand on the rear handle and the left hand on
the front handle.
WARNING: Risk of electrocution! Do not
operate within 10 m of overhead electrical
power lines. Position the product at an angle
of 60° or less, depending on the specific
situation. Keep bystanders at least 15 m
away.
WARNING: Do not use the product on a
ladder or unstable support. Always cut with
both feet on solid ground to prevent being
pulled off-balance.
1. Make sure to position the ribbed bumper
to the main limb or trunk before making
the cut.
2. Make a shallow first cut (1/4 of limb
diameter) on the underside of the limb
close to the main limb or trunk. Then,
make a second cut from the top side
of the limb outboard from the first cut.
Lastly, make a final cut close to the
trunk. For second and final cuts (from
top of limb or branch), hold the bucking
spikes against the limb being cut. Allow
the chain to cut for you. Exert only light
downward pressure.
10m
≥15 m
(50')
1
2
2
1
≤60˚
3
11
Operation
Advertisement
Table of Contents
