Craftsman 316.794801 Operator's Manual page 7

The completed blower tube should l ook like Figure 6.
Throttle Cables
Upper Blower Tube
Throttle Grip
First Lower
Blower Tube _-_
Second Lower
Blower Tube
Nozzle
Fig. 6
Elbow Tube
Hose Clamp
Flex Tube
_J
-_ Hose Clamp
__ On/Off Switch
Cruise Control
WARNING:
To avoid serious personal injury, make
sure that the blower tubes are locked in place or firmly
installed.
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables (Fig.
7) as shown, making sure not to crimp the cables.
Zip Tie
Zip Tie
Fig. 7
Adjusting the Throttle Grip
1. Move the throttle grip to a location on the upper blower tube
that is comfortable for you (Fig. 8).
A
Throttle Grip
Upper Blower Tube
Fig. 8
2. Using a Torx T-20 Torx screwdriver, tighten the two screws at
the bottom of the throttle grip (Fig. 9).
]
Fig. 9