Advertisement
Attach lower lid hinges to back of firebox using two #10-24x1/2" machine screws, a fiber washer on each side of
10
firebox, and #10-24 rectangular nuts per hinge. The center flat portion of the hinge should be on the bottom (see inset
below).
Fiber Washer
Qty. 8
#10-24X1/2'
Machine Screw
Qty: 4
Lower lid
hinge
Attach handle to front of lid using two #10-24 wing nuts. Attach upper lid hinges to back of lid using two
11
#10-24x1/2" machine screws, fiber washers, and #10-24 rectangular nuts per hinge. Hinges should
curve downward when properly installed.
Rectangular
NOTE:
nuts cannot be rotated when correctly positioned. Hold
rectangular
nuts in place and thread screws into nuts by hand, then fully
tighten with screwdriver
#10-24X1/2"
Machine Screw
Qty: 4
Fiber Washer
Qty. 10
#10-24 Wing Nut
Qty. 2
#10-24
Rectangular Nut
Qty. 4
18 • 473741008
NOTE: Rectangular nuts cannot be rotated when correctly positioned. Hold
rectangular nuts in place and thread screws into nuts by hand, then fully tighten
with screwdriver
#10-24
Rectangular Nut
Qty. 4
Lid
Center flat portion
of hinge on bottom.
Handle
Upper lid hinge
Advertisement
