Advertisement
(A) P
lace firebox onto cart. P
8
wing nut.
(B) Place burner assembly into firebox. Make sure venturi tubes and valves are correctly engaged. Place small end of venturi clip
into venturi tube and large part of clip around valve. If burner is not leveled from left to right, adjust the two screws attaching valve
to control panel in step 8B. Place control knobs on valves as shown in figure (A).
(C) Inside firebox, attach firebox and control panel with fiber washers and #8 sheet metal screws.
(D) Attach ignitor wire to electrode.
B
Attach side shelves with #10-24x1-3/4" machine screws.
9
osition heat shield as shown. Attach with #10-24x1-1/4" carriage bolt, fiber washers and #10-24
Correctly assembled
Burner Assembly
Qty: 2
#8 Sheet Metal
Screw
Firebox
A
Control knobs
Heat shield
Shelf
Right Side
valve in
burner tube and venturi clips
B
Venturi Tube
Venturi Clip
C
Left Side
Qty: 4
#10-24x1-1/4"
Carriage Bolt
Qty: 4
#10-24
Wing Nut
Qty: 6
Fiber Washer
Ignitor Wire
D
Qty: 8
#10-24x1-3/4"
Machine Screw
473741008 • 17
Advertisement
