Siemens RUGGEDCOM RSG909R Installation Manual page 37

RUGGEDCOM RSG909R
Installation Guide
WARNING!
Electric shock hazard – risk of serious personal injury and/or equipment interference. When shielded
cables are used, make sure the shielded cables do not form a ground loop via the shield wire and the
RJ45 receptacles at either end. Ground loops can cause excessive noise and interference, but more
importantly, create a potential shock hazard that can result in serious injury.
LEDs
Each port features an LED that indicates the state of the port.
Green (Solid)
Green (Blinking)
Off
Pin-Out
The following is the pin-out for the RJ45 male connectors:
8
Figure 25: RJ45 Ethernet Port Pin Configuration
Specifications
For specifications on the available copper Ethernet ports, refer to
Specifications".
Copper Ethernet Ports
State
1
Description
Link established
Link activity
No link detected
Name
Pin
10/100Base-TX
1 RX+
2 RX-
3 TX+
4 Reserved (Do
Not Connect)
5 Reserved (Do
Not Connect)
6 TX-
7 Reserved (Do
Not Connect)
8 Reserved (Do
Not Connect)
Section 5.4, "Copper Ethernet Port
Communication Ports
Description
1000Base-TX
BI_DB+ Receive Data+ or
Bi-Directional
BI_DB- Receive Data- or
Bi-Directional
BI_DA+ Transmit Data+
or Bi-Directional
BI_DD+ Bi-Directional
BI_DD- Bi-Directional
BI_DA- Transmit Data- or
Bi-Directional
BI_DC+ Bi-Directional
BI_DC- Bi-Directional
Chapter 4
27