Siemens RUGGEDCOM RSG909R Installation Manual page 19

RUGGEDCOM RSG909R
Installation Guide
Mounting the Device
To mount the device to a DIN rail, do the following:
1. Position the device in front of the DIN rail and then hook the upper part of the DIN rail bracket onto the DIN
rail.
1
2
Figure 3: Mounting the Device to a DIN Rail
1. DIN Rail 2. DIN Rail Bracket
2. Push the bottom of the device towards the DIN rail until the release mechanism clicks into place.
3. Gently lift the bottom of the device to make sure the device is locked in place.
Removing the Device
To remove the device from a DIN rail, do the following:
1. Pull the release at the back of the device down and hold. If clearance is limited, insert the tip of a flathead
screw driver into the slot at the bottom of the release and use leverage to pull the release down.
Mounting the Device on a DIN Rail
Chapter 2
Installing the Device
9