Misalignment Between Gloss And Matte In Flxfinish+ Mode - Canon Colorado 1630 Operation Manual

Misalignment between gloss and matte in FLXfinish+ mode

Misalignment between gloss and matte in FLXfinish
Introduction
The misalignment is visible as white lines between the gloss and matte parts of the print.
Problem description
Misalignment be-
tween gloss and matte
in FLXfinish
Procedure
1. Perform a media calibration.
misalignment between matte and gloss in 1st meter (40") of the print, caused by the media step.
2. Make sure that the [Automatic advance correction] setting in the RIP is enabled. Use enhanced
Change the media settings on page
markers.
3. After printing for about 0.5-0.7 m with [Automatic advance correction] enabled, the automatic
advance correction will have optimized the media step. Any misalignment between matte and
gloss in FLXfinish
After you finish
When the problem is not solved, contact your application specialist or local Service
representative.
356 Chapter 9 - Troubleshooting and support
More likely to be visi-
ble in the 1
+
mode a print.
Calibrate the media on page
+
mode will then also disappear.
Cause
Media step not accu-
rate
st
meter of
67.
+
mode
Action
Perform a media cali-
bration.
113. A media calibration will minimize