Refill The Chiller (New Design) - Canon Colorado 1630 Operation Manual

Refill the chiller (new design)

Refill the chiller (new design)
Introduction
You can refill the chiller without service assistance.
NOTE
There are 2 types of chillers. In the first design, the condenser surface is located on the left side
of the chiller. In the new design, the condenser surface is located directly behind the cover. This
procedure describes the new design.
First design
When to do
Refill the chiller when the fluid level is near the bottom of the green zone on the level gauge
Vacuum the chiller and check the fluid level (new design) on page
glass. See
Before you begin
Use Colorado 1630 prescribed:
• Demineralized water
• Pouring can
• Screwdriver (Torx-25)
NOTE
For information on the prescribed maintenance materials, see
maintenance materials on page
CAUTION
Wear specified gloves when you refill the chiller to protect your skin.
IMPORTANT
Only refill one liter of demineralized water. When you use more the liquid can spill and damage
the machine.
Procedure
1. On the operator panel, tap on the [System] icon on the right.
2. Tap on [Power management].
242 Chapter 6 - Maintain the system
New design
255.
234.
List of Colorado 1630