Dell W32C Owner's Manual page 96

Steps
1. Gently place the system board on the display-assembly base.
2. Align the screw holes on the system board with the screw holes on the display-assembly base.
3. Replace the seven screws (M3x5) that secure the system board to the display-assembly base.
4. Replace the screw (M3x12) that secures the system board to the display-assembly base.
5. Connect the touchscreen cable (TOUCH) to the system board.
6. Connect the display-backlight cable (LCB BACKLIGHT) to the system board.
7. Connect the camera cable (WEBCAM) to the system board.
8. Connect the processor-power cable (ATX CPU) to the system board.
9. Connect the fan cable (FAN CPU) to the system board.
10. Connect the control-signal cable (CTRL) to the system board.
11. Connect the system-board power cable (ATX SYS) to the system board.
12. Connect the power-supply fan cable (FAN SYS) to the system board.
13. Connect the audio cable (MB-AUDIO) to the system board and close the latch.
14. Connect the high-speed cable (MB-HS) to the system board and close the latch.
15. Connect the power cable (MB-PWR) to the system board and close the latch.
16. Connect the display cable (CVDS) to the system board.
Next steps
1. Install the processor.
2. Install the heat sink.
3. Install the wireless card.
4. Install the M.2 2230 solid-state drive in M.2 slot 0
5. Install the M.2 2230 solid-state drive in M.2 slot 1
6. Install the I/O bracket.
7. Install the bottom cover.
8. Install the I/O cover.
9. Install the system-board
10. Install the memory.
96 Removal and installation procedures for High Performance processors
shield.
or the M.2 2280 solid-state drive in M.2 slot
or the M.2 2280 solid-state drive in M.2 slot
0, whichever applicable.
1, whichever applicable.