4. Route the antenna cables through the routing guides on the display-assembly base and the power-supply fan.
5. Route the audio-board cable through the routing guides on the display-assembly base and the power-supply fan.
6. Thread the power-supply fan cable under the I/O bracket and route the power-supply fan cable through the routing guide on
the display-assembly base.
7. Connect the power-supply fan cable (FAN SYS) to the system board.
Next steps
1. Install the
bottom
cover. .
2. Install the
power-supply
3. Install the
I/O
cover.
4. Install the
system-board
5. Install the
back
cover.
6. Install the stand.
7. Follow the procedure in
I/O bracket
Removing the I/O bracket
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
system-board
5. Remove the
I/O
cover.
6. Remove the
bottom
cover.
About this task
The following image(s) indicate the location of the I/O bracket and provides a visual representation of the removal procedure.
82
Removal and installation procedures for High Performance processors
unit.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.