Stihl RMA 235.1 Instruction Manual page 33

7 Assembling the Lawn Mower
► Push screws (3) together with washers (2)
through the bores in lower handlebar (1) and
lawn mower (4) from the outside inwards,
screw in and tighten to 3 Nm.
Both lower handlebars (1) are firmly attached
to lawn mower (4).
► The upper handlebar can be installed at 2
heights (a, b).
► Hold upper handlebar (5) against lower han‐
dlebars (1) so the bores align.
► Place cable (10) into cable clip (8).
► On the side with the cable, push screw (6)
through bores (11) in cable clip (8), upper han‐
dlebar (5) and lower handlebar (1) from the
outside inwards.
► On the other side, push screw (6) through
bores (11) in upper handlebar (5) and lower
handlebar (1) from the outside inwards.
► Fit rotary knob (9) onto screws (6) on both
sides and screw in.
Upper handlebar (5) is firmly attached to lower
handlebars (1).
► Place cable (10) into cable clip (7).
► Press cable clip (7) onto upper handlebar (5)
and allow to engage.
► Place cable (10) into cable clip (12).
► Press cable clip (12) onto lower handlebar (1)
and allow to engage.
The handlebar must not be dismantled again.
7.2 Folding Up and Folding the
Handlebar
7.2.1 Folding Up the Handlebar
► Switch the lawn mower off and remove the
battery.
0478-131-9667-B
► Place the lawn mower on a level surface.
► Fold up upper handlebar (2) and hold with one
hand. Make sure that cable (4) is not dam‐
aged.
► Tighten rotary handles (1).
Handlebar (2) is firmly attached to the lawn
mower.
Upper handlebar (2) is firmly attached to lower
handlebar (3).
7.2.2 Folding the Handlebar
The handlebar can be folded for space-saving
transport or storage.
► Switch the lawn mower off and remove the
battery.
► Place the lawn mower on a level surface.
► Unscrew rotary handles (1) until they turn
freely.
English
33