Table of Contents
Advertisement
Stick Welding (MMA)
This machine does not include a MMA welding kit cables,
but may be purchased separately. Refer to the
accessories section for more information.
First determine the proper electrode polarity for the
electrode to be used. Consult the electrode data for this
information. Then connect the output cables to the output
terminals of the machine for the selected polarity. Shown
here is the connection method for torch.
Connect the electrode cable to the torch terminal and the
work clamp to the work piece terminal.
connector with the key lining up with the keyway and
rotate approximately ¼ turn clockwise.
tighten.
Polarity for Stick can be selected between (DC+, DC-, AC)
by front panel push button and menu, see following.
TIG Welding (GTAW)
This machine does not include a TIG torch necessary for
TIG welding, but one may be purchased separately.
Refer to the accessories section for more information.
Connect the torch cable to
the torch terminal of the
machine
and
the
work
clamp to the work piece
terminal.
Insert
the
connector with the key
lining up with the keyway
and rotate approximately ¼ turn clockwise. Do not over
tighten. Finally, connect the gas hose from the TIG torch
to the gas connector (B) on the front of the machine. If
necessary, an extra gas connector for the fitting on the
front of the machine is included in the package. Next,
connect the fitting on the back of the machine to a gas
regulator on the cylinder of gas to be used. The required
fittings are included in the package. Connect the TIG
torch trigger to the trigger connector (A) on the front of the
machine.
English
TIG Welding with a Water Cooled Torch
A cooling unit can be applied to the Machine:
COOLARC-24
If a Coolarc unit listed above is connected to the Machine,
it will be automatically turned ON and OFF in order to
ensure the torch cooling. When Stick welding mode is
used the cooler will be OFF.
This machine does not include a cooled TIG torch, but
one may be purchased separately.
accessories section for more information.
The Machine is provided with an electrical connection for
the Coolarc unit on its rear side. This socket is ONLY for
the connection of the Coolarc unit listed above.
Before connecting the cooler unit to the Machine and
operate, read and understand the Instruction Manual
supplied with the cooling unit.
Insert the
Connect and disconnect the cooler with the unit switched
Do not over
OFF.
Remote Control Connection
Refer to the accessories section for a list of
remote controls. If a remote control is used, it
will be connected to the remote connector on
the front of the machine. The machine will
automatically detect the remote control, turn
on the REMOTE LED, and switch to remote control mode.
More information on this mode of operation will be given in
the next section.
Rear Panel
A. Power Switch: It turns ON /
OFF the input power to the
machine.
B. Input cable: Connect it to the
mains.
C. Fan: Do not obstruct or filter
the fan inlet. The "F.A.N." (Fan
As
automatically turns OFF/ON
the fan. The fan will start with
welding operations and will
continue to run whenever the
Machine is welding. If the
Machine doesn't weld for more than 10minutes, it will
go in Green Mode.
Green Mode
The Green Mode is a feature that puts the machine in
a stand-by condition:
8
WARNING
WARNING
WARNING
Needed)
feature
The output is disabled
The fans are speed down
All LEDs on the front panel are switched OFF
except the Power ON LED (solid ON) and the
VRD LED (solid ON) if the VRD is enabled
Display show the dash char
Refer to the
English
Advertisement
Table of Contents
