Vulcan-Hart VGCTS16 Service Manual page 12

ROUND COUNTERTOP TILTING BRAISING PANS (16 GALLON) Gas and Electric - REMOVAL AND
Shut off the gas before servicing the
unit and follow lockout / tagout
procedures.
All gas joints disturbed during servicing must be
checked for leaks. Check with a soap and water
solution (bubbles). Do not use an open flame.
A. Disconnect the component lead wires for
the HSI, FSP, HL, and TC from the terminal
strip located in the left-hand console, and
pull the insulation sleeve and wires through
the opening in bearing.
B. Remove those same components from the
underside of pan, and set them aside for
reinstallation on replacement pan
assembly.
Fig. 13
C. Loosen the nut at the top of the burner that
secures the burner to bracket and remove.
D. Unscrew the gas orifice and remove.
E. Separate the brass union just below the gas
swivel connector, and unscrew the threaded
end of the connector from the pan sleeve.
F. Loosen the set screw at the top of the
actuator collar, and remove the collar.
F24643 (1217)
REPLACEMENT OF PARTS
G.
5. Unbolt the braising pan from the mounting
surface or stand.
6. Lay the braising pan on its back to expose the
four base plate mounting nuts and bolts.
7. Remove the nuts and carriage bolts on the right
side to separate the right side support member.
Page 12 of 26
Fig. 14
Disconnect the incoming gas supply line.
Remove the gas line assembly by
separating the second union in the gas
assembly line, and removing the nuts
securing the mounting bracket.
Fig. 15