Using your Shower
Read the section "Important Safety Information" first.
1.
Switch on electrical supply
and press 'Start/Stop'
button
3.
Allow 10 - 15 seconds for temperature adjustments to reach overhead/handset.
4.
Check water temperature before
entering shower.
6.
Press STOP button. Shower flow
will continue for a few seconds
before stopping. Switch off electrical
supply.
Note!
At the end of every shower make sure that the overhead and handset point
into the catchment area. A small amount of water may be retained in the overhead or
handset after the shower has been turned off. This may drain over a few minutes.
2.
5.
+
_
7.
21
Set desired heater level.
+
_
Turn handle through 90° to switch flow
between overhead and handset.
A small amount of water may drain
over a few minutes. Switch flow to
overhead.