Mira Divisa Installation And User Manual page 12

Thoroughly flush the mains-fed cold water supply pipe. The supply must
be clean and free from debris BEFORE connecting the Mira Divisa.
To flush the pipework, turn on the water supply and drain a minimum of 10 litres (2
gallons) of water into a bucket or catchment area. Turn off the water supply.
An installation template and checklist is supplied to help you install the Mira
Divisa.
Mark the positions of the fixing holes to secure the shower to the wall. Before
drilling into the wall, make sure that the holes are clear of any buried cables or
pipework. Make sure that a sufficient length of electrical supply cable is available
for connection to the terminal block.
Drill and plug the fixing holes. Secure the shower to the wall with the three
screws provided. Alternative screw fixings (not supplied) may be necessary for
some wall structures.
Install the mains-fed cold water supply
pipe. Do not overtighten.
Feed cable into case. Fit earth sleeve
(not supplied) and strip insulation.
12
Important! Make
sure that the inlet
earth wire is routed
as shown. Failure
to do so may cause
product malfunction.