Table of Contents
Advertisement
Installation
Installation of Mira Divisa
Warning! Turn off the electrical and water supplies before proceeding with the
installation of the Mira Divisa. The electricity must be turned off at the mains and
the appropriate circuit fuse electrically isolated, if applicable.
Remove the three cover retaining
screws.
Remove the cover.
Remove the service tunnel.
Determine the direction of the inlet
water supply: top (falling), bottom
(rising), or back inlet.
Note!
Make sure that the back inlet
does not go directly back into the wall.
Use a soldered elbow.
Swivel the inlet connector to suit.
Remove the inlet blanking cap.
trapping the green earth bonding
wire.
Service Tunnel
Avoid
11
Advertisement
Table of Contents
