Table of Contents
Advertisement
Assemble the grey part of the bracket
to part C as shown until it locks. Feed
plastic pipe through and assemble both
to part B. Then mark the bracket holes
(one per side).
Remove parts B, C and the bracket
and separate part B. Drill and plug the
holes.
Do not drill into buried pipes or
cables.
Alternative screw fixings (not supplied)
may be necessary for some wall
structures.
Feed plastic pipe back through part B
and part C and then refit part B to part
A. Secure the bracket to the wall and
fit the Shroud.
Note!
Make sure the handset holder is
the right way up.
Make sure all parts are pushed fully
home so the excess plastic pipe is
within the dimension shown.
Grip plastic pipe and feed into part D.
Push plastic pipe fully home to make
sure of seal.
Tip:
using washing up liquid may aid
assembly of plastic pipe to part D.
Secure with retaining screw, then fit
overhead and washer to part D.
Check overhead is level and free to
move as shown.
Place one flat seal in both ends of hose
and fit one end to Part A. Fit handset
to hose.
Locator Hole
Locator Pin
30-50mm
x 1
x 1
15
Hardened
Surface
Advertisement
Table of Contents
