Sony HDMI VPL-FH300L Operating Instructions Manual page 43

Setting items Functions
IR Receiver Selects the remote control detectors (IR Receiver) on the
front and rear of the projector.
• Front & Rear: Activates both the front and rear
detectors.
• Front: Activates the front detector only.
• Rear: Activates the rear detector only.
If the remote commander does not work well or works
false operation affected by a fluorescent lamp, set the
remote sensor on the fluorescent lamp to off.
ID Mode Assigns an ID number (1 to 3) to the projector when you
want control two or more projectors individually with the
supplied Remote Commander. When this item is set to "1,"
you can control the projector with the Remote Commander
with the ID MODE key set to "1." When it is set to "All,"
you can control all the projectors with the Remote
Commander independently of the ID MODE keys of the
Remote Commander.
Illumination Lights the SONY logo on the top panel while the projector
is on. Select its brightness from among "High", "Medium"
and "Low", or select "Off" if you do not want it to light.
Direct Power On Set to "On" if you are using a circuit breaker to turn the
power on/off the entire system. You can turn the power on/
off without pressing the power key on the projector.
Note
Depending on the picture position adjusted with the lens shift feature, the aspect ratio of the picture
may change from the original or picture distortion may occur with V Keystone adjustment.
Initial setting
Front & Rear
All
High
Off
The Installation Menu
43