Sony HDMI VPL-FH300L Operating Instructions Manual page 33

Next menu window
Setting items
4
Make the setting or adjustment of an
item.
• When changing the adjustment
level:
To increase the number, press the M or
, key.
To decrease the number, press the m or
< key.
Press the ENTER key to restore the
previous screen.
• When changing the setting:
Press the M or m key to change the
setting.
Press the ENTER key to restore the
previous screen.
You can restore the previous screen
using < depending on the selected
item.
To clear the menu
Press the MENU key.
The menu disappears automatically if a key
is not pressed for one minute.
To reset items that have been
adjusted
To reset the setting of the items, there are the
following two ways.
• Select "Reset" in the Picture menu.
Do you wish to reset the settings
to default values ?
Low
Film
Off
Select "OK" when the screen display
appears. The following settings are reset to
their factory preset values:
The items that can be reset are as follows:
"Contrast," "Brightness," "Color," "Hue,"
"Color Temp," "Sharpness," "DDE,"
"Black Level Adj.," and "Gamma Mode"
in the Picture menu.
• Press the RESET key on the Remote
Commander.
To reset the value of an item back to its
factory preset value, press the RESET key
while a setting item is displayed on the
screen.
Unadjustable items
The adjustable items are limited depending
on the input signals. The items that cannot be
adjusted or set do not appear in the menu.
For details, see page 44.
Storage of the settings
The settings are automatically stored in the
projector memory when the ENTER key is
pressed.
If no signal is input
If there is no input signal, "Cannot adjust
this item." appears on the screen.
33
Using a MENU