Table of Contents
Advertisement
11.2.4 Configuring a multipoint adjustment
Bosch Motorsport
Available measurements for channel:
Measurement label
raw_name
raw_name_fi
name
name_fi
Note
Working with automatically created measurement sheets is explained in chapter 'Setting
up an online measurement [} 73]'.
Example: Measurement of wheel force
– Physical property 'wheel force' not directly measureable
– Load transfer through suspension kinematics
– Physical value at sensor position defined by vehicle
– Curve definition by online adjustment at vehicle
1.
Click on 'Measurement Sources' in the Toolbox.
2.
Expand the list of 'I/O Channels' by clicking on '+' in the VCU MS 50.4 Project Tree.
3.
Drag the 'Multipoint Adjustment' analog signal source from the Toolbox and drop it
on the desired analog input channel in VCU MS 50.4 Project Tree.
Drag + Drop
Vehicle_Control_Unit_VCU_MS_50.4_Manual
Analog and Frequency Inputs | 11
Function
mV value of sensor
filtered mV value of sensor
physical value of sensor
filtered physical value
61 / 136
Advertisement
Table of Contents
