Air Conditioning System Maintenance; Lubricating Moving Parts Of The Bodywork; Windshield Wiper - Alfa Romeo Giulia 2024 Owner's Manual

A C S M
IR ONDITIONING YSTEM AINTENANCE
To ensure the best possible performance, the air
conditioning system must be checked and undergo
maintenance at an authorized dealer at the beginning
of the summer.
CAUTION!
Do not use chemicals to clean the air conditioning
system, since the internal components may be
damaged. This kind of damage is not covered by
warranty.
Replace The Cabin Air Cleaner
For the correct servicing intervals page 256. For
cabin air cleaner replacement, contact an authorized
dealer.
WARNING!
Use only refrigerants and compressor lubricants
approved by the manufacturer for your air
conditioning system. Some unapproved refrigerants
are flammable and can explode, injuring you. Other
unapproved refrigerants or lubricants can cause the
system to fail, requiring costly repairs. Refer to
Warranty Information Book, located in your owner's
information kit, for further warranty information.
L M P O
UBRICATING OVING ARTS F
B
ODYWORK
Ensure that the locks and bodywork junction points,
including components such as the seat guides, door
hinges (and rollers), trunk and hood are periodically
lubricated with lithium-based grease to ensure correct,
silent operation and to protect them from rust and
wear.
Thoroughly clean the components, eliminating every
trace of dirt and dust. After lubricating, eliminate
excess oil and grease. Also pay particular attention to
the hood closing devices, to ensure correct operation.
During operations on the hood, to be carried out with
the engine cold, also remember to check, clean and
lubricate the locking, release and safety devices.
Lubricate the external lock barrels twice a year. Apply a
small amount of high-quality lubricant directly into the
lock barrel.
If necessary, contact an authorized dealer as soon as
possible.
W W
INDSHIELD IPER
Periodically clean the windshield and rear window and
rubber profile of the windshield wiper blades, using a
sponge or a soft cloth and a non-abrasive detergent.
This eliminates the salt or impurities accumulated
when driving.
Prolonged operation of the windshield wipers with dry
glass may cause the deterioration of the blades, in
addition to abrasion of the surface of the glass. To
eliminate the impurities on the dry glass, always
operate the windshield washers.
T
In the event of very low outdoor temperatures, below
HE
0°F (-17.8°C), ensure that the movement of the rubber
part in contact with the glass is not obstructed. Use a
suitable deicing product to release it if required.
Avoid using the windshield wipers to remove frost or ice.
Also avoid contact of the rubber profile of the blades
with petroleum derivatives such as engine oil, gas, etc.
Driving with worn windshield wiper blades is a
serious hazard, because visibility is reduced in bad
weather conditions.
NOTE:
The life of the windshield wiper blades varies according
to the usage frequency. In any case, it is advised to
replace the blades approximately once a year. When
the blades are worn, noise, marks on the glass or
streaks of water may be noticed. In the presence of
these conditions, clean the windshield wiper blades or,
if necessary, replace them.
Raising The Windshield Wiper Blades (Service Position
Function)
The Service Position function allows for easier
replacement of the windshield wiper blades. It is also
recommended for snow or for removing any dirt
deposits during washing in the area where the blades
are normally positioned.
Activation Of The Function
Disable the windshield wipers before placing the
ignition in the OFF position.
This function can only be activated within two minutes
of placing the ignition in OFF.
WARNING!
269