Alfa Romeo Giulia 2024 Owner's Manual page 106

If the system is set, the previously described conditions
also cause a cancellation or deactivation of the system.
These situations may vary according to the conditions.
NOTE:
The system will not be deactivated when speeds higher
than those set are reached by pressing the accelerator
pedal above 110 mph (180 km/h). In these situations,
the system may not work correctly and it is
recommended to deactivate it.
The driver should always obey traffic laws and speed
limits. Never drive above applicable speed limit
restrictions.
To Activate/Deactivate
The system has four operating states:
□
Enabled (speed not set)
□
Activated (speed set)
□
Paused
□
Deactivated
To Activate
To enable the system, push and release the on/off
button located on the left side on the steering wheel.
On/Off Button
104
When the system is enabled and ready to operate, the
display shows the white ACC icon above dashes in place
of the speed.
Enabled Icons
Setting a speed activates the system. The display shows
the icon in green with the set speed.
WARNING!
Leaving the Adaptive Cruise Control (ACC) system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have a collision. Always
leave the system off when you are not using it.
To Pause/Deactivate
With the feature enabled (speed not set), push the
on/off button to disable.
With the feature active (speed set), push the on/off
button to pause. The display will show the icon in white
with the speed in brackets. To deactivate the feature,
push the on/off button a second time.
To Set A Desired Speed
When the vehicle reaches the desired speed, push the
RES/SET switch downward and release it to activate the
system. When the accelerator is released, the vehicle
will maintain the set speed automatically.
SET Switch
While the accelerator pedal is pressed, the system will not
be able to control the distance between the vehicle and
the one ahead. In this case, the speed will be determined
only by the position of the accelerator pedal.
The system will return to normal operation as soon as
the accelerator pedal is released.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
Once the system has been activated, you can increase
the speed by pushing the RES/SET switch upward or
decrease the speed by pushing the RES/SET switch
downward. Each time the switch is pushed, the speed is
adjusted by 1 mph.
Pushing and holding the switch upward or downward
will cause the set speed to adjust in 5 mph increments
until the button is released. The new set speed is
reflected in the instrument cluster display.