Table of Contents
Advertisement
Viewing Snapshots and Movies on a TV Screen
1.
Use the AV cable that comes with the camera to connect it to the TV.
Yellow
Video
TV
AUDIO IN jacks (white)
VIDEO IN jack (yellow)
Making sure that the
lens side, connect the cable to the camera.
• Make sure that you insert the cable connector into the
USB/AV port until you feel it click securely into place.
Failure to insert the connector fully can result in poor
communication or malfunction.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector as
shown in the illustration.
2.
Turn on the TV and select its video input mode.
If the TV has more than one video input, select the one where the camera is
connected.
3.
Press [
] (PLAY) to turn on the camera.
This will cause an image to appear on the TV screen, without anything appearing
on the camera's monitor screen.
• You also can change the aspect ratio of the screen and the video output
system (page 90).
4.
Now you can display images and play back movies as you normally do.
IMPORTANT!
• Before connecting to a TV to display images, be sure to configure the camera's
[
] (REC) and [
• Audio is initially output by the camera at maximum volume. When you first start
displaying images, set the TV volume control at a relatively low level and then
adjust it as required.
White
Audio
mark on the AV cable connector is towards the
] (PLAY) buttons for "Power On" or "Power On/Off" (page 88).
AV cable (bundled)
62
[USB/AV] port
Advertisement
Table of Contents
