Removal Of The Vrb Boards - Cornelius 2 Flavor Training Manual

Quest Juice Training Manual
R
EMOVAL OF THE
1. Remove the cover.
2. Remove the connectors.
3. Loosen and remove the nut and insulation.
4. Turn the box over and locate the standoffs on
the VRB board to be removed. Gently
squeeze with a needle nose pliers. This will
release the standoff and allow it to be pushed
back through the hole in the bracket.
5. The VRB board can now be removed from the
electrical box itself.
6. The standoffs (4) can be removed by gently
squeezing the tip with needle nose pliers and
at the same time pushing through the board.
NOTE: The nut and insulation must be
assembled as illustrated. Failure to assemble
and tighten correctly can result in component
overheating causing the concentrate pump
not to run.
Publication Number: TP00968
VRB B
OARDS
- 20 -
Lock washer
Washer
Insulator pad
Insulator washer
© 2004, IMI Cornelius Inc.