Wolf CT15I Technical & Service Manual page 25

I I n n d d u u c c t t i i o o n n C C o o o o k k t t o o p p
Generator Removal
First, extract screws securing baffle, located at the front
of generator, and remove. (See Figure 4.11).
Next, extract screws securing left front, left rear and
right rear burner mounting brackets and remove. (See
Figure 4.12 and 4.13).
NOTE: Care must be taken when removing right rear
burner mounting bracket due to wiring in this location.
Remove two rear screws that secure generator to burn-
er box. (See Figure 4.14).
Remove ground screw located at rear left side of gener-
ator and disconnect L1 and Neutral leads. (See Figure
4.15).
Next, lift rear locking clips on generator and slide gener-
ator assembly towards front of burner box, then lift to
remove generator. (See Figure 4.16).
NOTE: Generator must be moved forward enough to
allow tabs securing generator to burner pan allowing
proper room for removal. (See Figure 4.17).
Figure 4.11. Baffle removal.
Figure 4.12. Left rear mounting bracket removal.
Figure 4.13. Front left and right rear mounting bracket.
Component Access and Removal
Figure 4.14. Remove rear screws securing generator.
Ground Screw
Figure 4.15. Remove gnd screw and L1& N leads.
Figure 4.16. Lift locking clips at rear of generator.
Figure 4.17. Slide generator to front until tabs release.
4-5
Locking
Clips