Installation Procedures - Wolf CT15I Technical & Service Manual

I I n n d d u u c c t t i i o o n n C C o o o o k k t t o o p p
INDUCTION COOKTOP
INSTALLATION PROCEDURE
Install
•
Insert cooktop into countertop opening and center cooktop. Check that the front edge of the cooktop is
parallel to the front edge of the countertop. Check that all
required clearances are met.
• To
attach hold down brackets to the sides of the unit, insert
holddown clip into the rectangular punch-out in the pan and
push down.
•
Install the clamping screws into the bracket and tighten until
screw contacts the underside of the countertop.
(See Figure 2-5).
NOTE: Do not over tighten screws.
NOTE: Do not use caulk or silicon to secure the unit to the countertop.
Installation of Multiple Cooktops
If this cooktop is to be used with any combination of additional cooktop units or modules with a filler strip, the cut-out
width is calculated by adding the corresponding units' cut-out dimensions plus 1-1/4" (32 mm) for each additional
unit. (See Figure 2-6).
1
2 / "
2 min
(64)
3
59 / "
4 (1518) FOUR MODULES CUT-OUT WIDTH
1
44 / "
2 (1130) THREE MODULES WIDTH
(See Design Guide)
1
29 / "
4 (743)
TWO MODULES WIDTH
14" 19
(356)
(489)
CUT-OUT CUT-OUT
WIDTH DEPTH
FRONT OF COUNTERTOP
Figure 2-6. Multiple Cooktop Installation
(See Design Guide)
1
/ "
4
NOTE: Dimensions in parentheses are in millimeters.
2-5
Installation Information
COOKTOP
COUNTERTOP
BRACKET
1
3 /
2
CLIP CLAMPING
SCREW
Figure 2-5. Attaching Hold Down Clamp
"
(89 mm)