Wolf CT15I Technical & Service Manual page 23

I I n n d d u u c c t t i i o o n n C C o o o o k k t t o o p p
Glass Top Assembly Removal
The cooktop will have to be removed from its installa-
tion in order to remove the glass top assembly.
NOTE: Refer to the installation section of this manual or
the Installation Guide included with the cooktop for
additional information needed.
Extract screws that secure the glass top and trim to
burner box. (See Figure 4.1).
Next, carefully lift glass top up until access to control
board connections are obtained.
Locate ribbon cable connector on glass top, gently dis-
connect from control board. (See Figure 4.2).
Next, lift tabs located on bottom center portion of molex
connector and disconnect cable. (See Figure 4.3).
Now remove glass top assembly.
Control Board Removal
Lay glass top down so the control board points upward.
NOTE: Care must be taken to protect glass surface
from scratches or damage. Place on protective sur-
face.
Now, push in the tabs which mount control board to
keypad board. (See Figure 4.4).
Next, lift control board straight up and off of tabs and
remove. (See Figure 4-5).
NOTE: Care must be taken to ensure connector pins
are not bent.
Figure 4.4. Control Board Tabs.
Component Access and Removal
Figure 4.1. Glass Top Removal.
Figure 4.2. Control Board Ribbon Cable Removal.
Figure 4.3. Control Board Molex Connector Removal.
Figure 4.5. Control Board Removal.
4-3
R 10 6
C20
R 10 5
1001
R36
R 10 9
R 1 10
3R3
R39
R37
R49
R48
R 1 10
331
R 10 6
C21
C20
R 10 5
C18
1001
R 10 9 R36 C22
R 1 10
3R3
R39
R37
R49
R42 R36 R30
R48
R 1 1
331 R23
DIS2
R12
C26
R32
R42
R21
R34
R35
R66
R20
R13
C11
C19
C14