Pre-Installation Specifications; Countertop Location; Overhead Cabinet Dimensions - Wolf CT15I Technical & Service Manual

I I n n d d u u c c t t i i o o n n C C o o o o k k t t o o p p
INDUCTION COOKTOP

PRE-INSTALLATION SPECIFICATIONS

Countertop Location

Dimension Description
A Minimum flat countertop surface. Must be equal to
or greater than cooktop width.
B Minimum 2-inches (152mm) wide clearance from
the cooktop side edge to any combustible surface
up to 18 inches (457mm) above the cooktop
(noted by shaded area).
C Minimum 2-inches (152mm) wide clearance from
the cooktop side edge to any combustible surface
up to 18 inches (457mm) above the cooktop
(noted by shaded area).

Overhead Cabinet Dimensions

Dimension Description
D Minimum spacing between cabinets directly over cooktop, must be greater than or equal to the nomi-
nal width of the cooktop unit.
E Minimum 18 inches (457mm) vertical distance from the countertop surface to the bottom of cabinets
adjacent to the cabinet directly above the cooktop unit.
F Minimum 24-inches (610mm) clearance between the top of the cooking surface and the bottom of
wood or metal cabinet which is protected by not less than 1/4-inch (6mm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015-inch (.4mm) stainless steel or 0.024-inch
(.5mm) copper. Minimum 30" (762mm) clearance between the top of the cooking surface and the bot-
tom of an unprotected wood or metal cabinet.
G Minimum 1-1/2-inches (38mm) from rear wall.
H Maximum 13-inch (330mm) depth of overhead cabinets.
G
NOTE: Dimension may vary by ± 1/8" (3mm).
D
F
B
Figure 2-2. Pre-Installation Specifications
2-3
Installation Information
21"
(533mm)
15"
(381mm)
Figure 2-1. Overall Dimensions
H
E
A
3 1/4"
(83mm)
C