Important Instructions
>
>
Notes on the Administrator Password
Resetting the Administrator Password
Notes on the Administrator Password
This device allows you to set an administrator password to prevent unauthorized third parties from accessing or
changing the device settings or the network settings stored in the device when it is connected to a network.
If you set an administrator password, you need to enter the password when changing settings in configuration
software such as Web Config.
The initial administrator password is set on the scanner, but you can change it to any password.
Initial Administrator Password
The initial administrator password varies depending on the label attached to the product. If there is a
"PASSWORD" label attached to the back, enter the 8-digit number shown on the label. If there is no "PASSWORD"
label attached, enter the serial number on the label attached to the base of the product for the initial administrator
password.
We recommend changing the initial administrator password from the default setting.
Note:
No user name is set as default.
Operations that Require the Administrator Password
If you are prompted to enter the administrator password during the following operations, enter the administrator
password set on the product.
❏ When logging on to the advanced settings for Web Config
❏ When changing the device settings in the application
❏ When updating the firmware for the device
❏ When changing or resetting the administrator password
Changing the Administrator Password
You can change the administrator password in Web Config.
When changing the password, the new password must be 8 to 20 characters long and only contain single-byte
alphanumeric characters and symbols.
Related Information
"Configuring the Administrator Password" on page 172
&
Resetting the Administrator Password
By resetting the network settings, you can restore the administrator password to its original setting at the time of
purchase.
Note:
Resetting the administrator password also resets the user name.
12