Epson ES-C320W User Manual page 100

Required Settings for Scanning
1. Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
2. Press the button on the scanner's control panel until the
Connection setup begins. The
The is lit blue when connection is complete.
Note:
Connection fails when the light turns on. After clearing the error by pressing the
move it closer to the scanner, and then try again.
Related Information
"Checking the Network Connection Status" on page 165
&
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can connect to an access point by using a PIN code. You can use this method to set up if an access point is
capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Press the button and the
in white (approximately 3 seconds).
2. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the scanner into the
access point within two minutes.
The connection setup begins. The
The is lit blue when connection is complete.
Note:
❏ See the documentation provided with the access point for details on entering a PIN code.
❏ Connection fails when the light turns on. After clearing the error by pressing the
move it closer to the scanner, and then try again.
>
Connecting the Scanner to the Network
light and light flash alternately.
button on the scanner's control panel simultaneously until
light and light flash alternately.
100
>
Connecting to the Wireless L
light flashes white (approximately 3 seconds).
button, restart the access point,
button, restart the access point,
...
light flashes