Selecting the Right Tip
Tip Hole Size
•
Spray should be atomized (evenly distributed, no
gaps or edges). Start at a low pressure setting,
increase pressure a little at a time until paint atom-
izes.
•
Fluid flow rate is controlled by tip hole size.
•
The best tip hole size for fluid you are spraying is
determined by type of coating and type of surface
you are spraying.
•
Use large tip hole size when spraying thicker coat-
ings.
Tip Hole Size
(diameter based on area of
elliptical orifice)
0.013 in. (0.33 mm)
0.015 in. (0.38 mm)
0.017 in. (0.43 mm)
0.019 in. (0.48 mm)
Maximum Tip Size:
A30 - 0.017 in. (0.43mm)
A45 - 0.019 in. (0.48mm)
Fan Width
Fan Width is the size of the spray pattern.
Narrow Fan
• Thicker coat
•Better control
•Small, confined surfaces
Wide Fan
•Thin coat
•Fast coverage
•Broad, open surfaces
3A1177B
stains
enamels
X
X
X
•
Use small tip hole size when spraying thinner coat-
ings.
•
Tips wear and enlarge when you spray. Starting with
a tip hole size smaller than the maximum will allow
you to spray within rated flow capacity. To prevent
excessive wear, spray at lowest pressure that atom-
izes paint.
NOTE: If maximum pressure of sprayer is not enough
for good spray pattern, tip is too large or worn. See
Reversible Tip Selection Table, page 14.
COATINGS
oil-based
interior latex
primers and
paint
paints
X
X
X
X
X
X
Selecting the Right Tip
exterior latex
acrylics
paint
X
X
X
X
X
13