Troy-Bilt 31AH5ER9563 Operator's Manual page 18

Three-stage snow thrower
Table of Contents

Advertisement

Chute Directional Control
To adjust the chute control rod, proceed as follows:
1.
Remove the cotter pin from either of the holes closest to
the chute assembly on the chute rotation assembly.
2.
Pull out the chute control rod until the hole in it lines up
with the hole furthest from the chute assembly on the
chute rotation assembly. See Figure 6-6.
3.
Reinsert the cotter pin through this hole and the chute
control rod. See Figure 6-6.
18
S
6 — M
ection
aintenance
Figure 6-6
& a
djuStMentS
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow
the storage instructions below.
1.
Lubricate the machine as instructed earlier in this section.
2.
Store in a clean, dry area.
3.
If storing the snow thrower in an unventilated area,
rustproof the machine using a light oil or silicone to coat
the snow thrower.
4.
Clean the exterior of the engine and the snow thrower.
IMPORTANT: When storing unit or when it is not being serviced,
it is to remain in the operating position with both wheel and
auger housing on the ground.
NOTE: Refer to the Engine Operator's Manual for information on
storing your engine.

Advertisement

Table of Contents
loading

This manual is also suitable for:

31bh5er9563

Table of Contents