Wired Handset Mounting Using The Holster - Raymarine RAY63 Installation And Operation Instruction Manual

1. Check the selected location for the Hook plate, a clear flat area is required, with sufficient space
around it to place and remove the Fistmic / Handset and coiled cable.
2. Using a pencil, offer up the Hook plate to the desired location and mark the location of the
screw holes on the mounting surface.
3. Drill the mounting holes using a suitable size drill bit.
4. Hold the Hook plate in place and secure using the screws provided.
5. Hook the Fistmic / Handset over the Hook plate and gently push down until it clicks into position.
Important:
• The Fistmic can only be hooked and unhooked from the Hook plate when held vertically.
• Drill bit, tap size and tightening torque is dependent on the thickness and type of material the
unit is to be mounted on.

Wired handset mounting using the holster

Follow the steps below to mount the wired handset.
Before mounting, ensure that your selected location meets the location requirements found in
this document.
64