Maintenance - MULTIQUIP V305EK Operation Manual

CAUTION
Inspection and other services should always be carried
out on hard and level ground with the engine shutdown.
INSPECTION AND MAINTENANCE SERVICE TABLES
To make sure your vibratory roller is always in good
working condition before using, carry out the maintenance
inspection procedures.
Table 5. Machine Inspection
ITEM
Loose or Missing Screws
Damaged Parts
Function of Controlling
System Part
Eaton Hydrostatic
Transmission
Vibrator Oil Check
V-belt (clutch) Check
NOTICE
These inspection intervals are for operation under
normal conditions. Adjust your inspection intervals
based on the number of hours the roller is in use and
your particular working conditions.
Table 6. Engine Check
ITEM
Oil or Fuel Leak
Tightness of Fastening
Threads
Engine Oil Check and
Replenishment
Engine Oil Replacement
Air Filter Cleaning
PAGE 26 — V305EK VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #0 (07/20/23)
HOURS OF OPERATION
Every 8 hours (every day)
Every 8 hours (every day)
Every 8 hours (every day)
Every 100 hours
Every 50 hours
Every 200 hours
HOURS OF OPERATION
Every 8 hours (every day)
Every 8 hours (every day)
Every 8 hours (every day)
(Replenish to specified
maximum level)
After first 25 hours then
every 50 to 100 hours
Every 50 hours
DAILY SERVICE
1. Check for leakage of fuel or oil.
2. Check for loose screws and tighten to the proper
torque:
SPARK PLUG
1. Remove and clean the spark plug (Figure 32).
2. Adjust the spark gap to 0.028 ~0.031 inch (0.7~0.8
mm). This unit has electronic ignition, which requires
no adjustments.
GAP:
0.028 – 0.031 in.
(0.7 – 0.8 mm)
Figure 32. Spark Plug Gap
ENGINE OIL
1. Drain the engine oil when the oil is warm as shown in
Figure 33.
2. Remove the oil drain bolt and sealing washer and allow
the oil to drain into a suitable container.
3. Replace engine oil with recommended type oil as listed
in Table 4. Engine oil capacity is 1.4 quarts (1.3 liters).
DO NOT overfill.
4. Install drain bolt with sealing washer and tighten
securely.
OIL FILLER
DIPSTICK
DRAIN
BOLT
Figure 33. Engine Oil (Draining)

MAINTENANCE

SEALING
WASHER