Engine Components - MULTIQUIP V305EK Operation Manual

11
10
12
9
8
7
Figure 8. Engine Components
INITIAL SERVICING
The engine (Figure 8) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to the
manufacturer's engine manual for instructions and details
of operation and servicing.
1. Fuel Filler Cap — Remove this cap to add unleaded
gasoline to the fuel tank.
DANGER
Add fuel to the tank only when the engine
is stopped and has had an opportunity to
cool down. In the event of a fuel spill, DO
NOT attempt to start the engine until the
fuel residue has been completely wiped up
and the area surrounding the engine is dry.
2. Fuel Tank — Fill with unleaded gasoline. Refer
to Table 2 for fuel tank capacity. Make sure cap is
tightened securely. DO NOT over fill. For additional
information, refer to Kohler engine owner's manual.
V305EK VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #0 (07/20/23) — PAGE 19
1
2
3
4
5
6

ENGINE COMPONENTS

3. Throttle Lever —Used to adjust engine RPM speed.
4. Engine On/Off Switch — ON position permits engine
starting, OFF position stops engine operation.
5. Dipstick/Oil Filler Cap — Remove this cap to
determine if the engine oil is low. Add oil through this
filler port as recommended in Table 4.
6. Oil Drain Plug — Remove this plug to remove oil from
the engine's crankcase.
7. Recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
8. Fuel Valve Lever — OPEN to let fuel flow, CLOSE to
stop the flow of fuel.
9. Choke Lever — Used in the starting of a cold engine,
or in cold weather conditions. The choke enriches the
fuel mixture.
10. Air Cleaner — Prevents dirt and other debris from
entering the fuel system. Remove wing-nut on top of
air filter canister to gain access to filter element.
NOTICE
Operating the engine without an air filter, with a
damaged air filter or a filter in need of replacement,
will allow dirt to enter the engine, causing rapid engine
wear.
11. Muffler — Used to reduce noise and emissions.
NEVER touch when hot!
12. Spark Plug — Provides spark to the ignition system.
Set spark plug gap according to engine manufacturer's
instructions. Clean spark plug once a week.