Maintenance - MULTIQUIP MIX N' GO MC3PBAT Operation Manual

DRIVE BELT INSPECTION (ONCE A YEAR)
1. Remove the drive belt cover as shown in Figure 26.
2. Next inspect the drive belt for wear. If it shows signs
of wear or cracks, replace drive belt.
3. Reinstall drive belt cover. Tighten retaining screws
securely.
DRIVE-BELT
SLACK
BOLT (2X)
Figure 26. Drive Belt Inspection
BATTERY CHARGER
1. Disconnect/remove controller power cord (Figure 27A)
from battery.
2. Silde charger protective receptacle cap (Figure 27B)
to open position.
3. Insert battery charger connector (plug) into battery
charging receptacle (Figure 27C).
4. Insert battery charger AC plug into a 120 VAC
receptacle (Figure 27D).
MIX N' GO MIXER • MC3PBAT • OPERATION MANUAL — REV. #0 (04/09/24) — PAGE 21
CRACKS
NUT (2X)
DRIVE-BELT
COVER
DISCONNECT CONTROLLER
A
POWER CORD FROM BATTERY
B
SLIDE
PROTECTIVE CAP
TO OPEN POSITION
Figure 27. Charging Battery
5. Place key switch in the ON position and verify that
the battery status LED on the battery charger is RED
(Figure 28A), indicating battery is charging.
6. Battery is fully charged when the battery status LED
on the battery charger is GREEN (Figure 28B).
RED INDICATES
BATTERY IS
CHARGING
STATUS LED
BATTERY CHARGER
Figure 28. Battery Charger Status LED

MAINTENANCE

C
INSERT BATTERY CHARGER
PLUG INTO BATTERY CHARGING
RECEPTACLE
BATTERY CHARGER
D
CONNECT BATTERY
BATTERY
CHARGER PLUG TO
120 VAC OUTLET
A
GREEN INDICATES
BATTERY IS
FULLY CHARGED
BATTERY
B