Sherwood RD-7108 User Manual page 23

Sherwood rd-7108: user guide
Table of Contents

Advertisement

Select the desired preset number (1~30) and
press the MEMORY/ENTER button.
3
TUNING/PRESET
• When using the NUMERIC buttons on the remote
control.
Examples) For "3" :
3
within 2 seconds
For "15" :
1
For "30" :
0
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is
stored automatically without pressing the
MEMORY/ENTER button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If "MEM" goes off, start again from the above step 2.
Tuning to preset stations
After selecting the tuner as an input
source, select the preset mode.
1
T/P MODE
• Then "PRESET" lights up.
Listening to FM stereo broadcasts
• While listening to FM broadcasts.
• Each time this button is pressed,
the FM mode changes as follows;
Stereo mode : "ST" lights up.
Mono mode : "ST" goes off.
• When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.
4
MEMO/ENTER
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
5
• Preset stations,etc.
Note : If the electricity fails or the AC input cord is
2
• When using the NUMERIC buttons on the remote
control.
Examples) For "3" :
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
tuning mode.
Scanning preset stations in sequence
FM MODE
• The receiver will start scanning the stations in the preset
sequence and each station is received for 5 seconds.
• At the desired station, press this button again to stop
scanning.
2 4
Repeat the above steps 1 to 3 to memorize
other stations.
disconnected for more than 2 weeks, they are all
cleared. So you should memorize them again.
Select the desired
preset number.
3
within 2 seconds
For "15" :
1
For "30" :
0
POWER
P .SCAN
P .SCAN
TUNER
CD
AUX
TAPE
VIDEO1
VIDEO2
VIDEO3
7CH DIR
DISC
REPEAT
A<>B
CD
INTRO
A
DECK SEL
TAPE
B
AUTO
DSP
STEREO
MUTE
T.TONE
VOL.
LEVEL
CH.SEL
LEVEL
SLEEP
DIMMER
VOL.
SPK SET
PL
PARA.
ADJUST
1
2
3
4
5
6
7
8
9
0
REMOTE CONTROL UNIT
RM-109
TUNING/PRESET
5

Advertisement

Table of Contents
loading

Table of Contents