Sherwood RD-7108 User Manual page 19

To cancel the surround mode for stereo operation
• Then the stereo mode is selected.
• To cancel the stereo mode, select the desired surround mode with using the DSP MODE
Adjusting the Dolby Pro Logic II Music parameters
• When selecting the Dolby Pro Logic II Music mode, you can adjust the various surround parameters for optimum
surround effect.
Press the PL II MUSIC PARAMETER button to select the desired parameter.
3
• Each time this button is pressed, the parameter changes and is displayed for several seconds as follows;
Panorama mode("PANO", default value : OFF)
This mode extends the front stereo image to include the surround speakers for an exciting "wraparound"
effect with side wall imaging. Select "OFF" or "ON".
Center width control("C-WID", default value : 0)
This adjusts the center image so it may be heard only from the center speaker, only from the left/right
speakers as a phantom image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control("DIMEN", default value : 0)
This gradually adjusts the soundfield either towards the front or towards the rear. The control can be set in 7
steps from -4 to +2.
At the desired parameter, adjust it as desired.
4
POWER
TUNER
VIDEO1
DISC
ADJUST
A
DECK SEL
B
AUTO
MUTE
or
LEVEL
SLEEP
1
6
REMOTE CONTROL UNIT
• If the parameter display disappears, start from the
step 3 again.
POWER
P .SCAN
TUNER CD AUX TAPE
VIDEO1 VIDEO2 VIDEO3 7CH DIR
STEREO
DISC REPEAT
A<>B
CD INTRO
A
DECK SEL TAPE
B
DSP
AUTO STEREO
or MUTE T.TONE
VOL.
LEVEL LEVEL
CH.SEL
SLEEP DIMMER
VOL.
SPK SET PL
PARA.
ADJUST
1 2 3 4 5
6 7 8 9 0
REMOTE CONTROL UNIT
RM-109
POWER
P .SCAN
TUNER CD AUX TAPE
VIDEO1 VIDEO2 VIDEO3 7CH DIR
PL MUSIC PARAMETER DISC
REPEAT
A<>B
CD INTRO
A
DECK SEL TAPE
B
AUTO DSP STEREO
MUTE T.TONE
or
VOL.
LEVEL LEVEL
CH.SEL
SLEEP DIMMER
VOL.
SPK SET PL
PARA.
ADJUST
1 2 3 4 5
6 7 8 9 0
REMOTE CONTROL UNIT
RM-109
P .SCAN
CD AUX TAPE
VIDEO2 VIDEO3 7CH DIR
REPEAT
A<>B
CD INTRO
TAPE
DSP
STEREO
T.TONE
VOL.
CH.SEL LEVEL
ADJUST
DIMMER
VOL.
SPK SET PL PARA.
ADJUST
2 3 4 5
7 8 9 0
RM-109
2 0
STEREO
or
PL PARA.
Repeat the above steps 3 and 4 to adjust
other parameters.
5
button.