Sherwood RD-7108 User Manual page 20

Adjusting each channel level
Select the desired channel.
6
POWER
TUNER CD AUX
VIDEO1 VIDEO2 VIDEO3
DISC
CHANNEL
CD
SELECTOR
A
DECK SEL
TAPE
B
AUTO DSP
MUTE T.TONE
or
VOL.
LEVEL LEVEL
CH.SEL
SLEEP DIMMER
VOL.
SPK SET PL PARA.
ADJUST
1 2 3 4
6 7 8 9
REMOTE CONTROL UNIT
RM-109
Adjust the level of the selected channel
as desired.
7
POWER
TUNER CD AUX
VIDEO1 VIDEO2 VIDEO3
DISC
CD
ADJUST
A
DECK SEL TAPE
B
DSP
AUTO
MUTE
or
VOL.
LEVEL
CH.SEL
SLEEP
VOL.
SPK SET PL PARA.
ADJUST
1 2 3
6 7 8
REMOTE CONTROL UNIT
RM-109
Repeat the above steps 6 and 7 to adjust each channel level.
8
Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the 7 CH DIRECT is selected as an input source or the SPEAKER button is set to off, the test tone
function does not work.
Enter the test tone mode.
9
POWER P .SCAN
TUNER CD AUX TAPE
VIDEO1 VIDEO2 VIDEO3 7CH DIR
DISC REPEAT
A<>B
CD INTRO
A
DECK SEL TAPE
B
AUTO DSP STEREO
MUTE T.TONE
VOL.
LEVEL LEVEL
CH.SEL
SLEEP DIMMER
VOL.
SPK SET PL PARA.
ADJUST
1 2 3 4 5
6 7 8 9 0
REMOTE CONTROL UNIT
RM-109
P .SCAN
TAPE
7CH DIR
REPEAT
A<>B
INTRO
STEREO
CH.SEL
5
0
P .SCAN
TAPE
7CH DIR
REPEAT
A<>B
INTRO
STEREO
T.TONE
LEVEL LEVEL
LEVEL
DIMMER
4 5
9 0
T.TONE
2 1
• Each time this button is pressed, the corresponding
channel is selected and displayed for several seconds
as follows:
FL C FR
Front Left Center Front Right
DTS L DD L
Dolby Digital LFE
or DTS LFE
• You can adjust the LFE level for Dolby Digital or
DTS program source that includes LFE signal.
• When it is in the stereo or Dolby Virtual mode or the
speaker setting is "N", center, surround L/R, surround
back or subwoofer channel will not be selected.
• When the SPEAKER button is set to off, only the
front L/R channel can be selected.
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the setting
as necessary.
• If the channel display disappears, start from the step
6 again.
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR SR
SW
• When the speaker setting is "N", the test tone of the
corresponding channel is not available.
SR SB
Surround Surround
Right Back
SW SL
Subwoofer Surround
Left
SB SL