System Reset Defaults - DSC TL280LE-LAT Instruction Manual

[993] Ethernet Gateway Address
This section will display the IP address of the Ethernet gateway. This value is programmed in section [003] or assigned by
DHCP.
[994] Cellular IP Address
This section will display the current dynamic IP address assigned by DHCP to the cellular connection.
NOTE: Cellular uses DHCP (dynamic IP) only. The cellular IP address is always provided by the cellular network (i.e., not
programmable).
[995] SIM Number
This section will display the Subscriber Identity Module (SIM) number of the SIM card installed in the communicator. Format
is: Major Industry Identifier (2 digits); Mobile Country Code (2 or 3 digits); Mobile Network Code (2 - 3 digits); Unique Num-
ber (10 - 12 digits); and Checksum (1 digit). Valid SIM numbers range is: 18 - 21 numbers. This number is printed on the
SIM and the outside of the communicator carton.
NOTE: The checksum digit is omitted on 19-digit SIM card numbers.
[996] Cellular Telephone Number
NOTE: This section will display the cellular telephone number of the SIM. This telephone number is required by the Installer
for DLS and remote firmware (flash) update. User can access this telephone number by entering [*] [6] < > "Cellular
Phone No." to display the phone number.
[997] IMEI Number
This section will display the unique 15-digit International Mobile Equipment Identity (IMEI) of the radio. Format is: Reporting
Body Identifier (2 digits), Allocation Number (4 digits); Final Assembly Code (2 digits); Serial Number (6 digits); and a check
digit.
[998] MAC Address
This section will display the unique12- digit, hexadecimal number assigned as the Media Access Control (MAC) address of
the device.

System Reset Defaults

[999] Software Default
Default (99);
The software default allows the installer to refresh the unit after changes and also returns the communicator to the default
state.
00: Default Module. All programming sections in the module revert to factory settings. This will erase all existing pro-
gramming of the unit.
55: Reset. The communicator is reset. This option is equivalent to power cycling the communicator.
51