Table of Contents
Advertisement
ON: Cellular receiver 2 is enabled.
OFF: Cellular receiver 2 is disabled.
Options 2: Cellular Receiver 2 Supervision Enabled - Default OFF
ON: Cellular receiver 2 is supervised and heartbeats are sent to cellular receiver 2 based on the supervision interval pro-
grammed in section [217].
OFF: Cellular receiver 2 is not supervised.
[211] Cellular Receiver 2 Account Code
Default (0000000000)
The account code is used by the central station to distinguish between different transmitters. This account code is used
when transmitting signals to the central station receiver. Signals received on the panel will use the panel account number.
Valid range: 0000000001 - FFFFFFFFFE.
NOTE: Programming this section as all 0's or F's will cause a module configuration trouble (yellow LED = 12 flashes).
[212] Cellular Receiver 2 DNIS
Default (000000)
The DNIS is used in addition to the account code to identify the communicator module at the central station. Valid range:
000000 - 099999. Values are entered as a 0 followed by the 5-digit DNIS value. Format is BCD.
[213] Cellular Receiver 2 Address
Default (000.000.000.000)
Enter the cellular receiver 2 IP address. This IP address will be provided by the central station. Format is 4 fields, each field
is 3-digit decimal. Valid range: 000 - 255.
NOTE: When a valid address has been entered, cellular receiver 2 is enabled and will communicate events over the cel-
lular path.
[214] Cellular Receiver 2 Port
Default (0BF5/3061)
This section defines the port of cellular receiver 2. Change the value of this port when the installation is located behind a fire-
wall and must be assigned a particular port number, as determined by the central station system administrator. Valid range:
0000 - FFFF.
NOTE: Do not program cellular receiver 1 and cellula r receiver 2 to communicate to the same receiver.
[215] Cellular Receiver 2 APN
Default ( )
The APN determines the cellular network that the communicator will connect to. This information is available from the net-
work carrier. Program this section with up to 32 ASCII characters.
NOTE: When a SIM card with a custom APN is used, the unit will not have access to the Internet. DLS and remote flash can
still be done if section [221] is programmed with a valid public APN.
[216] Cellular Receiver 2 Domain Name
Default ( )
Enter the cellular receiver 2 Domain Name with up to 32 ASCII characters.
[217] Cellular Receiver 2 Supervision Interval
Default (0087/135 seconds)
The supervision interval is only valid when supervision has been enabled for Cellular receiver 2 in section [200] . The
receiver supervision interval determines the delay, in seconds, between each heartbeat signal sent to the central station
receiver. If the interval programmed is less than 10 seconds (000A) then supervision is disabled. The valid range for this
section is 000A – FFFF seconds.
NOTE: The supervision interval programmed in the central station receiver must be 65s longer than the interval pro-
grammed in the communicator to ensure stable operation.
Cellular Options
[221] Cellular Public Access Point Name
Default ( )
When the communicator is operating on a private APN, use this section to select a public APN for DLS and remote firmware
update. This information is available from the network carrier. The APN identifies the public cellular network that the com-
municator will connect to.
[222] Cellular Login User Name
Default ( )
Some network carriers require login credentials when connecting to an APN. Program the login user name in this section.
Enter the Cellular Login User Name with up to 32 ASCII characters.
34
Advertisement
Table of Contents
